Kenwood TM-D700A Service Manual

Adjustment Service Jig
TM-D700A/E
ADJUSTMENT
@Service jigs usage
@(Sac) @(PRI)
@(PR9)
@(OE} @(PKD)
Pin assignment seen from direction B
Data terminal short plug (W05-061 1-00)
COM DATA
(o0000)}
PANEL uic
| b_A CO
Short plug (9
Terminals @ and © are short circuited. "|
[Reference] @ PKS (SEND switch for DATA terminal) ZS
@Service jigs specification
Connect PTT output. If PKS is set to "L’,
data are sent and the microphone will be mute.
© SQC (Squetch contro! output)
This outputs squelch control output.
Plug cable with 6P mini-DIN : Model PG-5A (cable parts No. : E30-3202-05) processed like under fig.
Shield vire
ae
Approx, 1m
Bracket
Pin assignment seen from
direction A
(Cut the cable at suitalle length.)
Cut
unnecessary
wires
at
the
bottom
and
wind
DIN pinNo.j Color
1 Brown
2 Red
(3) Orange
4 Yellow
5 Green
(6) Blue
Bracket Shield
top edge.
>) S Orage wire
SS J
:
.
a
oin these DIN pins. SS) Short ircuit
(Soldeirsg)
insulation tape around piqe wire
E
1 Brown
2 Red
3 Orange
4 Yellow
| ; Green
39

Kenwood TM-D700A Specifications

General

Brand	Kenwood
Model	TM-D700A
Category	Transceiver
Language	English