Kenwood TM-D700A Service Manual

Transmission section
ADJUSTMENT
TM-D700A/E
Item
Condition
Measurement
Adjustment
Test-
equipment
Unit | Terminal
Unit
Parts Method
Specifications/
remarks
3. DEV
write or check
[Wide]
4) Down AG output from
the above state by
20dB (1kHz/2.0mV):E
20dB (1kHz/5.0mV):
K,M4
Transmission
[Narrow]
(E type only)
5) Band A
FREQ.:144.975MH2:E
AG:1kH2/20mV:E
Transmission
6) Band B
FREQ.:435.000MHz:E
AG:1kHz/20mV:E
Transmission
Power meter | Rear ANT
Linear panel
detector
Oscilloscope
AG
AF V.M
Check +2.34 ~ 4.47kHz:E
$2.38 ~ 4.05kHz:
K,M4
Check
£1.8 ~2.4Hz
Check
£1.8 ~2.4Hz
4. DCS balance
adjustment
Switch to adjustment
mode and carry out the
operations for Item E.
1) BandA
FREQ.:146.000MHz:K
FREQ.:144.975MHz:
M4,E
Transmission
2) Band B
FREQ.:444.000MHz:K
FREQ.:435.000MHz:
M4,E
Transmission
Power meter | Rear ANT
Linear panel
detector
Oscilloscope
Encoder | By turning
[SET] key | an
encoder,
adjust the
modulation
wave until
if becomes'
the square
wave
JUL
5. TONE DEV
write or check
Band A
[Wide]
For 1)and 4), Switch to
adjustment mode and
carry out the operations
for item F.
1) FREQ.:145.100MHz
TONE:88.5Hz
Transmission
2) FREQ.:145.100MHz
TONE:88.5Hz
Transmission
[Narrow]
(E type only)
3) FREQ.:145.100Hz:E
TONE:88.5Hz
Transmission
Band B
[Wide]
4) FREQ.:445.100MHz:K
FREQ.:435.100MHz:
M4,E
TONE:88.5Hz
Transmission
5) FREQ.:445.100MHz:K
FREQ.:435.100MHz:
M4,E
TONE:88.5Hz
Transmission
Power meter | Rear ANT
Linear panel
detector
Oscilloscope
Encoder | Write
[SET] key
+0.840.1 kHz
Check
+0.5 ~ 1.KHZz
Check
10.2 ~ 0.AHZ
Encoder | Write
[SET] key
+0.840.15(H1z
Check
+0.5 ~ 1.31H1z

Kenwood TM-D700A Specifications

General

Brand	Kenwood
Model	TM-D700A
Category	Transceiver
Language	English