Kenwood TM-D700A Service Manual

TM-D700A/E
ADJUSTMENT
Transmission section
Measurement Adjustment
Item
Condition
Test-
oo
.
Specifications/
. Unit | Terminal Unit Parts | Method
equipment remarks
TONE
DEV
6)
FREQ.:435,100MHz:E
|
Power
meter]
Rear
ANT
Check
+0.2
~
0.7kHz
write or check TONE:88.5Hz Linear panel
Band B Transmission detector
[Narrow] Oscilloscope
(E type only)
DCS DEV For 1) and 4), Switch to | Power meter} Rear ANT Encoder | Write +0.8+0.15kHz
write
or
check
|
adjustment
mode
and
Linear
—_
panel
[SET]
key
Band A carry out the operations | detector
[Wide] for Item G. Oscilloscope
1) FREQ.:145.200MHz
Transmission
2) FREQ.:145.200MHz Check +0.5 ~ 1.3kHz
Transmission
[Narrow]
3)
FREQ.:145.200MHz:E
Check
+0.2
~
0.7KHz
(E type only) Transmission
Band
B
4)
FREQ.:445.200MHz:K
Encoder
|
Write
+0.8+0.15kHz
[Wide] FREQ.:435.200MHz: [SET] key
M4,E
Transmission
Check
+0.5
~
1.3kHz
5) FREQ.:445.200MHz:K
FREQ.:435.200MHz:
M4,E
Transmission
[Narrow]
6)
FREQ.:435.200MHz:E
Check
+0.2
~
0.7kKHz
{E type only) Transmission
Protection
1)
Band
A
Ammeter
Check
12.0A
or
less
check FREQ.:146.000MHz:K
FREQ.:144.975MHz:
M4,E
POWER:HI
ANT:short circuit and
open
2) Band B 12.0A or less
FREQ.:444.000MHz:K
FREQ.:435.000MHz:
M4,E
POWER:HI
ANT:short circuit and
open
Transmission
52
** At the end of adjustments, reconfirm “3. DEV”.

Kenwood TM-D700A Specifications

General

Brand	Kenwood
Model	TM-D700A
Category	Transceiver
Language	English