470-BA-defs-0017
37
6 Selection of the mode setting
There are four mode settings::
Mode settings Indication Page
6.1 Weighing 1 SEt 1* 37
6.2 Weighing and parts counting 1 SEt 2 39
6.3 Weighing and percent 1 SEt 3 40
6.4 Weighing and conversion 1 Set 4 42
•
Manufacturer’s default.
The mode setting is kept even when the balance will be turned off.
In each mode setting weighing, pieces and percent presets with tolerance range are
possible point 7 „Weighing with tolerance range“.
In each mode setting accumulations of weight values, pieces and percent values are
possible , see pint 9 “Accumulation of indicated values“.
6.1 Mode setting „Weighing“
Setting see point 10 „General programmations“ on mode setting
„1 Set 1
“.
6.1.1 Weighing
Turn on the balance with the switch at the bottom of the right side of the casing. All
segments and signs will appear in the display in the frame of the self-controlling.
Then the indication changes to
0
. Now the balance is ready for use.
To secure the accuracy we recommend a warming-up time of minimum 15 minutes.
Only now (!) place the weighing object on the weighing plate. Take care that the
weighing object does not touch anywhere at the casing or at the base.
The weight determination is finished when the small ring
o (=stability detector)
appears in the left upper corner of the display.
Read the weighing result.
To Next Page
Loading...
Need help?
General
