KERN 470 Series User Manual

470-BA-defs-0017
42
6.3.2 Input of the reference weight using the keyboard.
Press
F
and release it when
P. SEt
Appears,
Now flashing display of the actual memorised reference weight corresponding to 100 %.
Example:
Press
TARE
,
0
starts to flash.
Input
3
By pressing three times
TARE
, move it with f by
one place
to the left, indication flashing
30
.
Input
2
by pressing twice
TARE
, move it with
F
by one place to the
left, indication flashing
320
.
Input
1
by pressing
TARE
and move it with
F
by
One place to the left, indication flashing
3210
.
Input
!
By pressing repeatedly
TARE
and move it with
F
by one
Place to the left, indication flashing
321.0
.
Input
5
By pressing repeatedly
TARE
.
Do not operate the F-key!
Confirm with S the 100 % reference weight of 321.5 g
Display
0,0 %
.
Further see point 6.3.1
6.4 Mode „weighing and conversion“
Serves to multiply the weight in „g“ of a weighing object on the weighing plate by a
factor. The following procedures can be performed automatically.
!
Conversions to foreign weight units
!
Conversions to complex units such as density (g/cm³), area weights (g/cm³)
or length weight (g/m)
!
Conversions to works-internal arithmetical units, for instance works
standards
This factor can be as well as greater or smaller than 0. Positive and negative numbers
can also be memorised.
Set to
1 SEt 4
With
F
and
TARE
, see point 10 „General programmations“.
TO SET THE CONVERSION FACTOR SEE POINT 6.3.2 „INPUT OF THE
REFERENCE WEIGHT USING THE KEYBOARD“
Input firstly the sign, then the figures before the decimal point, the decimal point,
and finally the figures after the decimal point.
Delete the conversion factor by new input of a conversion factor of „0“, then confirm
with
S
. Display
0
, the memory is deleted.

KERN 470 Series Specifications

General

Brand	KERN
Model	470 Series
Category	Scales
Language	English