KERN EG 620-3NM - Parameters When Weighing with a Tolerance Range (Excl. Model KERN EW120-4 NM)

EW/EG-N/EWB-e-1627
49
7.2.1 Parameters when weighing with a tolerance range
(excl. model KERN EW120-4NM)
Settings 21. Co. to 23. P I. can only be set if the tolerance weighing function
has been activated.
Function
Display
Choice
Description of the choice
possibilities
Display conditions of
the tolerance mark
21. Co. ☆1 Tolerance mark is always dis-
played, even if standstill check not
yet indicated.
2 Tolerance mark only displayed in
connection with standstill check.
Tolerance range 22.
L I. 0
Tolerance mark only displayed
above the zero point range (at
least + 5).
☆1 Tolerance mark displayed
throughout entire range.
Setting the tolerance
mark
23.
P I. 1
1 tolerance step is displayed:
“-“ or “+”
☆2
2 tolerance steps are displayed:
“- “ and “+”