KERN HFD Series - Adjustment

HFD-BA-e-1820 31
8. Adjustment

Switch-off balance and attach a carrying help if necessary.
 Switch-on balance with attached carrying help and during the selftest
press the TARE button. "P1 - - -" will be displayed.
 Enter password "000" :
Select a number by the M+ key
Increase the numeric value using the TARE key
Confirm by the ZERO key. The first function „F0 cal“ is displayed.
 Press the ZERO button, „UnLoAD“ will be displayed.
For verified models press the adjustment button at the balance bottom
 Unload the balance and wait until the [

] above appears.
 Press the ZERO button, the currently set adjustment weight is displayed.
 In order to change, select the number to be changed by the M+ button and
set the desired value using the TARE button, the active digit flashes.
 Confirm by the ZERO button, „LoAd“ will be displayed.
 Attach the adjustment weight and wait until the [

] above appears
 Press the ZERO button.
 After successful adjustment the balance carries out a selftest, then it automatically
returns to weighing mode.
An adjusting error or incorrect adjusting weight will be indicated by the error
message; repeat adjustment procedure