34 HFD-BA-e-1820
10. Error messages
Possible causes / Elimination
Err 1 Wrong date
Enter date in format "yy;mm;dd", see
chap.
7 "F7 da"
Err 2 Wrong time
Enter time in format “hh;mm;ss“, see
chap.
7 "F7 da"
Err 4 Error during zero setting
Zero range exceeded
Check if the balance is not loaded
Err 5 Keyboard error
Improper operation of the balance
Err 6
Value outside the A/D changer
range
Damaged weighing cell
Err 7
Error "Determination of
percentage"
Increase the value to >0.5 d
Err 8 Incorrect adjusting weight
Check value for adjustment weight, see
Err 9
The displayed weight is
permanently changing
Draught/air movement
Table/floor vibrations
Weighing pan has contact with other
Err 10 No WLAN connection
Check menu setting
Error "Communication log"
Check the communication settings
Err 12
Number of totalizing operations > 99
Capacity of balance exhausted
Err 15
Error "Gravitational constant"
Value out of range 09.xx -1.0xx
Err 17
Taring range exceed or not achieved
Err 19
Unable to initialise zero point
Measuring cell defective / overloaded
Object on weighing pan / contact
Main board defective
- - ol - -
Maximum load exceeded
Reduce load
Check whether the balance has been
--lo--
Underload
Negative weight, check platform and
Fai l h / fai l l
/ fai l
Check value for adjustment weight, see
chap. 1
Repeat adjustment process
Ba lo / lo ba
Capacity of rechargeable battery
exhausted
Recharge battery
Should other error messages occur, switch balance off and then on again. If the error
message remains inform manufacturer.
To Next Page
Need help?
General
