KERN KFB-TM User Manual

KFB/KFN-TM-BA_IA-e-1624 41
8.1 Overview non verifiable weighing systems
(contacts of circuit board [K1] not short-circuited)
Menu block
Main menu
Menu item
Submenu
Available settings / explanation
PO CHK
Weighing with
tolerance range,
see chap. 7.7
nEt H Upper limit value „Tolerance check weighing“, input see
chap. 7.7.1
nEt LO Lower limit value „Tolerance check weighing“, input see
chap. 7.7.1
PCS H Upper limit value „Tolerance check counting“, input see
chap. 7.7.2
PCS L Lower limit value „Tolerance check counting“, input see
chap. 7.7.2
BEEP no
Acoustic signal for weighing with tolerance range
switched off
ok Audio sound when load is within tolerance limits
nG Audio sound when load is beyond tolerance limits
P1 REF
Zero point
settings
A2n0 Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
0AUto Zero setting range
Load range where the display after switching-on the
balance is set to zero.
Selectable 0, 2, 5, 10, 20, 30, 50, 100 %
0rAGE Zero setting range
Load range where the display is set to zero by pressing
. Selectable 0, 2, 4, 10 , 20* , 50, 100%.
0tArE Automatic taring „on / off“, taring range adjustable in menu
item „0Auto“.
SPEEd Not documented
Zero Zero point setting
P2 COM
Interface
parameter
MODE
CONT
S0 off
Continuous data output,
selectable “send zero” yes / no
S0 on
ST1
One output for stable weighing value
STC
Continuous data output of stable weighing
values
PR1
Output after pressing
PR2
Manual totalizing, see chap. 7.8.
Press and the weighing value will be
added to the summation memory and issued.

KERN KFB-TM Specifications

General

Brand	KERN
Model	KFB-TM
Category	Monitor
Language	English