PRS/PRJ/ARS/ARJ-BA-def-0622 99
6 Unpacking, installation and commissioning
6.1 Place of installation, place of use
The balance is constructed in such a way that reliable weighing results can be achieved
under normal application conditions.
By selecting the correct location for your balance, you will be able to work quickly and
precisely.
Therefore please observe the following at the place of installation:
• Place the balance on a firm, level surface;
• Avoid extreme heat as well as temperature fluctuation caused by installing next to
a radiator or in direct sunlight;
• Protect the balance against direct draughts due to open windows and doors;
• Avoid jarring during weighing;
• Protect the balance against high humidity, vapours and dust;
• Do not expose the device to extreme dampness for long periods of time.
Inadmissible bedewing (condensation of air moisture on the device) can occur if a
cold device is taken into a significantly warmer environment. In this case, please
acclimatise the device for approx. 2 hours at room temperature after it has been
disconnected from the mains.
• Avoid static charging of the material to be weighed and weighing container.
Major display deviations (incorrect weighing results) are possible if electromagnetic fields
occur, as well as due to static charging, currents and unstable power supply. It is then
necessary to change the location.
6.2 Unpacking
Carefully remove the balance from the packaging, remove the plastic cover and install the
balance in the intended workplace.
To Next Page
Loading...
Need help?
General
