PRS/PRJ/ARS/ARJ-BA-def-0622 101
6.3.1 Windshield for PRS and PRJ balances (d=0.1 mg)
The position of the windshield on the
balance can be seen in figure 1 (see 2a).
Note:
If the windshield is not even after assembly,
it can be adjusted according to drawing
below.
Press down the higher corner (arrow) with
moderate force.
If necessary, turn windshield by 90° and
carry out the same operation again until the
windshield sits evenly.
To Next Page
Loading...
