KERN PRS

PRS/PRJ/ARS/ARJ-BA-def-0622 123
8.5 Print functions
To activate the menu see Chapter 7.4 “Activating the two main menus” and Chapter 7.5
“How the menu control operates”.
• SET
DATA
PRINT
AUTO-START ON/OFF
Start print automatically on
switch on/off
MODE UNSTABLE
Individual print, each value
MODE STABLE
Individual print, stable value
MODE LOAD CHANGE
Print after change of load
MODE CONTINUOUS
Continuous print after every
integration time
MODE TIMEBASE
Continuous print with timebase
TIMEBASE 2.0
Timebase (in seconds)
SET PRINT FORMAT
DATE AND TIME ON/OFF
BALANCE ID ON/OFF
PRODUCT ID ON/OFF
GROSS AND TARE ON/OFF
UNITS ON/OFF
OPERATOR ID ON/OFF
VERIFICATION MODE ON/OFF
PRODUCT * ttt...
PRODUCT MODE HOLD
PRODUCT MODE DELETE
PRODUCT MODE COUNT
OPERATOR ttt...
Using “SET PRINT FORMAT”, those elements which are switched on are printed in each
case:
• With “UNITS”, all units active at that time are printed out,
• with “PRODUCT ttt...”, the product name can be entered alphanumerically,
• with “PRODUCT MODE HOLD”, this product name is stored,
• with “PRODUCT MODE DELETE”, it is deleted after each expression,
• with “PRODUCT MODE COUNT” a counter is printed after every product name and
this counter is incremented by 1 after each print out.
• with “OPERATOR ttt...” the operator can be entered alphanumerically.
When a peripheral device (for example a printer) is connected, the balance interface must
be configured in the “SET INTERFACE” sub-menu (see Chapter 8.8 “Interface
functions”).
For further information on “Setting the print function”, see the example in Chapter 12.1.3.