Keto-Mojo GK+ - Setting Up Your System; Set the Date and Time Manually

6
CHAPTER 2: SETTING UP YOUR SYSTEM
Before you use your meter for the first time or if you change your meter batteries,
you should check and update your meter settings.
Set the Date and Time Manually
Note: Before your first use of the meter for testing, it is important to adjust the meter
settings to set the correct date and time, ensuring that results stored in the memory
are captured correctly.
1. Enter the setting mode and set the clock
When the meter is off, press and hold the power button for more than 2 seconds
until the meter beeps to enter the set-up mode. Press the side button to adjust and
set the clock for 12- or 24-hour mode, then press the power button to save your
choice. Now you can proceed to set the date.
2. Set the date
The year will now flash on the display. Press the side button to adjust it until the
year setting is completed, then press the power button until the meter beeps to set.
The display form of date and month will now flash, press the side button to set the
date display form for m/d or d/m mode, then press the power button to save your
choice. Start setting the month.