Kettler Unix P User Manual

Interruption/end of training
The electronics detects an interruption of the training in
case of less than 10 pedal revolutions/min or pressing
“RECOVERY”. The achieved training data is shown. Pulse,
strain, revolutions and speed are shown as average
values with Ø symbol.
Change to the current display by means of “Plus” or
“Minus”.
The training data is shown for 4 minutes.
If you do not press any buttons during this period and do
not exercise, the electronics switches over to standby
mode.
Resumption of training
If the training is continued within 4 minutes, the last values
will also be counted or counted down.
RECOVERY function
Measuring the recovery pulse
The electronics reversingly measures your pulse for 60
seconds and determines a fitness mark.
Press “RECOVERY” at the end of the training. The current
pulse value (in the figure “138”) is stored.
After 60 seconds the pulse value (in the figure “116”) is
stored again. The difference between both values (in the
figure “22”) is shown, based on which a fitness mark (in
the figure “F 3.5”) is determined. The display ends after
10 seconds.
“RECOVERY” or “RESET” interrupts the function.
If no pulse is measured at the beginning or end of the
time return, an error message will appear.
Training and Operating Instructions
28
GB
Pulse value at REC start
Pulse value after REC end
Difference (REC start-REC end)
Fitness mark

Kettler Unix P Specifications

General

Type	Magnetic cross trainer
Flywheel weight	20000 g
Transport wheels	Yes
Number of programs	8
Maximum user weight	150 kg
Optional heart rate measurement	Cardio pulse set, Chest belt
Standard heart rate measurement	Ear sensor, Hand grip sensors
Training displayed parameters	Calories, Distance, expected final score, Speed

Weight and Dimensions

Depth	1440 mm
Width	560 mm
Height	1520 mm