B3000 SERVICE MANUAL
60-200807-000, REV C 40
10. Install the new module and connect all of the appropriate connections, hoses, and wires making
sure that they are secure and tight.
11. Conduct a BIT test (see appendix VII on page 85) to insure the proper function of the brewer.
NOTE: There is a removable filter screen located in the Inlet Valve. If this screen should become
blocked by foreign material preventing water from flowing into the brewer, you can gently
remove the blocked screen using a pair of needle nose pliers and insert a new one. The part # for
the replacement screen is 01-201200-000.
Inlet Valve Screen
Inserted
Inlet Valve Screen
Removed
To Next Page
Loading...
