B3000 SERVICE MANUAL
60-200807-000, REV C 75
2. Join the coin changer cabinet to platform by placing the ‘hooks’ inside the platform slot. See
figures 4 and 5 below.
3. Place brewer on the platform such that the rubber feet of the brewer fit into the detent areas on
the platform and the brewer rests on top of the coin changer cabinet protrusions. See figure 6
below.
4. At the rear of the assembled brewer-coin changer cabinet locate the five holes for mounting the
Brewer-cabinet plate. Remove the five screws from the plastic accessory bag. See figure 7
below.
Figure 5
Figure 6
Figure 7
Figure 4
Figure 5
DETENTS
FOR
BREWER
To Next Page
Loading...
