Keyestudio EASY PLUG Ultimate Starter Kit - Page 146

www.keyestudio.com
143
Micro Servo Parameters:
 Operating voltage: DC 4.8V～6V
 Angle range: about 90°(in 1000→2000μsec)
 Pulsewidth range: 1000→2000μsec
 No-load speed: 0.12±0.01 sec/60（DC 4.8V）; 0.1±0.01 sec/60（DC
6V）
 No-load current: 200±20mA（DC 4.8V）; 220±20mA（DC 6V）
 Stop torque: 1.1±0.01kg/cm（DC 4.8V）; 1.3±0.1kg/cm（DC 6V）
 Stop current: 600±30mA（DC 4.8V）; 750±30mA（DC 6V）
 Standby current: 4±1mA（DC 4.8V）; 4±1mA（DC 6V）
 Operation temperature: -10℃～50℃
 Save temperature: -20℃～60℃
 Motor wire length: 250 ± 5 mm
Connect It Up
Connect the servo motor to EASY Plug Servo module. Brown line is for
ground, red one for V pin, orange one for signal pin.
Then connect them to control board using an RJ11 cable.