Keysight Technologies 8163A/B - Page 211

8163A/B, 8164A/B & 8166A/B Mainframes Programming Guide 211
Measurement Operations & Settings 4
command: :TRIGger[n][:CHANnel[m]]:INPut?
syntax: :TRIGger[n][:CHANnel[m]]:INPut?
description: Returns the incoming trigger response.
parameters: none
response: IGNore:
SMEasure:
CMEasure:
NEXTstep:
SWStart:
Ignore incoming trigger.
Start a single measurement. If a measurement function is active, see
:SENSe[n][:CHANnel[m]]:FUNCtion:STATe on page 104, one sample is performed and
the result is stored in the data array, see
:SENSe[n][:CHANnel[m]]:FUNCtion:RESult?
on page 100.
Start a complete measurement. If a measurement function is active, see
:SENSe[n][:CHANnel[m]]:FUNCtion:STATe on page 104, a complete measurement
function is performed.
Perform next step of a stepped sweep.
Start a sweep.
example: trig1:inp? -> ign<END>
affects: All tunable laser modules (except 81950A), power meters, and return loss modules, and attenuators with power control.
dual sensors: Can only be sent to master channel, slave channel parameters are identical.
command: :TRIGger[n][:CHANnel[m]]:INPut:REARm
syntax: :TRIGger[n][:CHANnel[m]]:INPut:REARm<wsp>OFF|ON|0|1
description: Sets the arming response of a channel to an incoming trigger.
See Table 8 on page -208, for information on how this command affects triggering power measurements.
parameters: A boolean value: OFF or 0: trigger rearming disabled
ON or 1: trigger rearming enabled (default)
If you return to Local control, all modules return to the default setting.
response: none
example: trig1:inp:rearm 0
affects: All 8163A/B series power meter modules, and 8161x series return loss modules.
dual sensors: Can only be sent to master channel, slave channel is also affected.