To Next Page

To Previous Page

116 Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide

Programming Examples

LAN Programming Interface Examples

VXI-11 Programming Using SICL and C++

The following program uses the VXI-11 protocol and SICL to control the signal

generator. Before running this code, you must set up the interface using the

Keysight IO Libraries IO Config utility. vxisicl.cpp performs the following

functions:

— sets signal generator to 1 GHz CW frequency

— queries signal generator for an ID string

—error checking

The following program example is available on the signal generator

Documentation CD-ROM as vxisicl.cpp.

//*****************************************************************

// PROGRAM NAME:vxisicl.cpp

// PROGRAM DESCRIPTION:Sample test program using SICL and the VXI-11

protocol

// NOTE: You must have the Keysight IO Libraries installed to run

this program.

// This example uses the VXI-11 protocol to set the signal generator

for a 1 gHz CW // frequency. The signal generator is queried for

operation complete and then queried

// for its ID string. The frequency and ID string are then printed

to the display.

// IMPORTANT: Enter in your signal generators hostname in the

instrumentName declaration

// where the "xxxxx" appears.

//*****************************************************************

#include "stdafx.h"

#include <sicl.h>

#include <stdlib.h>

#include <stdio.h>

Keysight Technologies N5166B CXG Programming Guide

Other manuals for Keysight Technologies N5166B CXG