Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 199
Programming the Status Register System
Status Groups
Data Questionable BERT Status Group
The Data Questionable BERT Status Group is used to determine the specific
event that set bit 12 in the Data Questionable Condition Register. The Data
Questionable Status group consists of the Data Questionable BERT Condition
Register, the Data Questionable BERT Transition Filters (negative and positive),
the Data Questionable BERT Event Register, and the Data Questionable BERT
Event Enable Register.
This status group applies only to signal generator models with Option
N5180UN7B. Refer to Table 4-8 on page 200 for more information.
To Next Page
Loading...
Need help?
General
