Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide 57
Using IO Interfaces
Using LAN
Figure 2-7 FTP Screen
The following steps outline a sample FTP session from the MS–DOS Command
Prompt:
1. On the PC click Start > Programs > Command Prompt.
2. At the command prompt enter:
ftp < IP address > or < hostname >
3. At the user name prompt, press enter.
4. At the password prompt, press enter.
You are now in the signal generator’s user directory. Typing help at the
command prompt will show you the FTP commands that are available on
your system.
5. Type quit or bye to end your FTP session.
6. Type exit to end the command prompt session.
To Next Page
Loading...
Need help?
General
