85
Chapter 3 Features and Functions
Pulse Width Modulation (PWM)
3
Pulse Waveform
• Pulse is the only waveform shape supported for PWM.
• Front-Panel Operation:Press .
• Remote Interface Operation:
FUNCtion {PULSe}
You can also use the
APPLy
command to select the function, frequency
,
amplitude, and offset with a single command.
Pulse Period
The range for the pulse period is 200 ns to 1000 s. The default is 1 ms.
• Front-Panel Operation: After selecting the pulse function, press the
Freq softkey again to toggle to the Period softkey. Then use the knob
or numeric keypad to enter the desired pulse period.
• Remote Interface Operation:
PULSe:PERiod {<seconds>|MINimum|MAXimum}
33210A users guide.book Page 85 Wednesday, July 16, 2008 11:16 AM
To Next Page
Loading...
