Keysight 34934A - Summary of SCPI Commands

SCPI Programming 4
Keysight 34934A User’s Guide 229
SCPI Commands Used by the 34934A
Command Summary
The commands listed below are used to control and query the operational state of
the 34934A. Not listed are commands whch apply to all
34980A modules.
In the following subsections are examples which highlight some of the more
commonly used commands listed above.
Subsystem Commands
DIAGnostic
DIAGnostic:RELay:CYCLes? (@<ch_list>)
DIAGnostic:RELay:CYCLes:CLEar (@<ch_list>)
ROUTe
ROUTe:CLOSe (@<ch_list>)
ROUTe:CLOSe? (@<ch_list>)
ROUTe:CLOSe:EXCLusive (@<ch_list>)
ROUTe:CLOSe:PAIR (@<ch_list>)
ROUTe:CLOSe:PAIR? (@<ch_list>)
ROUTe:MODule:BUSY? {slot | ANY}
ROUTe:MODule:WAIT <slot | ALL>
ROUTe:MODule:WAIT? <slot | ALL>
ROUTe:OPEN (@<ch_list>)
ROUTe:OPEN? (@<ch_list>)
ROUTe:OPEN:ALL [{<slot> | ALL}]
ROUTe:OPEN:PAIR (@<ch_list>)
ROUTe:OPEN:PAIR? (@<ch_list>)
ROUTe:OPERation:OVERlap[:ENABle] <mode>
ROUTe:OPERation:OVERlap[:ENABle]?
System - Related
Commands
SYSTEM:MODule:ROW:PROTection <slot>, <mode>
SYSTEM:MODule:ROW:PROTection? <slot>
SYSTEM:MODule:ROW:PROTection DEFault, <mode>
SYSTEM:MODule:ROW:PROTection? DEFault
SYSTEM:MODule:TERMinal:TYPE? <slot>