Getting Started 1
Keysight N1911A and N1912A Installation Guide 23
Remote Interface Configurations
The power meter can be remotely controlled by LAN, USB, and GPIB (IEEE488)
programming interfaces. This section shows you how to set the interface
configurations.
Only one interface should be used at any one time.
– Keysight IO Libraries Suite for Windows 98/2000/ME/XP. For information and
to install, use the Automation-Ready CD with Keysight IO Libraries Suite which
is shipped with the power meter.
– E2094M Keysight IO Libraries for Windows 98/NT/2000/ME/XP. You can find
information and install this application via the Web at
www.keysight.com/find/iolib.
– You can also access other information about Keysight IO Libraries at
www.keysight.com/find/iolib.
USB
The USB interface requires no front panel configuration.
USB operation and configuration is supported by the version of VISA and SICL IO
libraries on your PC.
To connect the power meter to your PC, configure and verify your connection,
you can use the Keysight IO Libraries Suite, the E2094M Keysight IO Libraries for
Windows, or an equivalent.
For more information on configurating the remote interface connectivity, refer to
the Keysight Technologies USB/LAN/GPIB Interfaces Connectivity Guide. If you
have installed the IO Libraries Suite, you can access the connectivity guide via
the Keysight IO Libraries Control icon. Alternatively, you can access the
connectivity guide via the Web at www.keysight.com/find/connectivity.
To Next Page
Loading...
