1 Getting Started
24 Keysight N1911A and N1912A Installation Guide
1 After I/O software is installed on your computer, connect your P-Series power
meter to your PC using the supplied Type A - Mini 5 pin USB cable.
2 The PC confirms the hardware connection as shown in Figure 1-1.
Figure 1-1 Example of initial connection Windows
3 The Found New Hardware Wizard automatically starts and guides you through
configuring the power meter as a USB device. Click
Next to install the software
automatically, accept all defaults to complete the installation.
Before connecting the USB cable, make sure that I/O software is installed on
your computer.
See “Remote Interface Configurations” on page 23 for information about the
Keysight IO Libraries software. If you have installed other I/O software, refer to
documentation that accompanies the software.
If you installed Keysight IO Libraries software, you also installed low-level
drivers. Therefore, you do not need to insert the CD when Found New Hardware
Wizards requests you to do so.
To Next Page
Loading...
