Getting Started 1
Keysight N1911A and N1912A Installation Guide 27
Dynamic mode
In dynamic mode the IP address, subnet mask, and default gateway values are
obtained from a DHCP server. When you use DHCP operation you cannot
configure the IP address, subnet mask, and default gateway values from the front
panel.
Using this dynamic mode does not require a detailed knowledge of your network
configuration.
1 Using a standard LAN patch cable, connect both the computer and the power
meter to LAN outlets.
2 Turn the power on the power meter.
3 Press ,
Remote Interfaces to display the Remote Interface display.
Ensure that DHCP to ON (ON is the factory default state).
To enable DHCP operation using the arrow and Select keys to highlight and
check DHCP is checked.
Figure 1-3 Typical LAN remote interface
If the DHCP server cannot be found on your network, the power meter returns to
the AutoIP mode, then static mode.
If your LAN does not support DHCP, refer to the connectivity guide.
To Next Page
Loading...
