Getting Started 1
Keysight N1911A and N1912A Installation Guide 33
Changing the GPIB address
The GPIB address is an integer between 0 and 30. The power meter is shipped
with a default address set to 13. The GPIB address is stored in non-volatile
memory.
To change the GPIB address manually proceed as follows.
1 Press ,
Remote Interfaces.
Figure 1-6 Typical GPIB remote interface
2 Use the arrow keys to highlight GPIB Address entry field.
3 Press and use the numeric keys to enter the GPIB address in the
Pop-up.
4 Press the Enter key
To change the address remotely.
You can set/query the GPIB address remotely using the following command
SYSTem:COMMunicate:GPIB:ADDRess.
To Next Page
Loading...
