1 Getting Started
32 Keysight N1911A and N1912A Installation Guide
GPIB
1 Install, or make sure you have installed, I/O software on your computer.
2 Follow your GPIB interface card vendor’s instructions for installing GPIB
hardware on your computer.
3 Connect a GPIB cable between your computer and the power meter.
4 Configure the installed GPIB card as the vendor instructs.
5 Use the Connection Expert utility of IO Libraries Suite to verify that the power
meter is displayed under the GPIB interface definition.
6 You can use various programming environments to control the power meter.
For further information, refer to your GPIB card vendor’s guide.
Refer to the refer to the connectivity guide and the programming guide for an
overview about programming the power meter.
If you have installed other I/O software, refer to documentation that
accompanies the software.
To Next Page
Loading...
