Getting Started 1
Keysight N1911A and N1912A Installation Guide 31
A pop-up appears for 5 seconds (see Figure 1-4). Monitor the Status at the
bottom of the Remote Interface display to see when the server has assigned an
address.
6 Press , to return to a measurement screen.
7 If you intend to program over LAN or use such programs, make sure you have
installed I/O software on your PC.
8 Use the Connection Expert utility of the IO Libraries Suite to add the power
meter and verify a connection.
9 You can use various programming environments to control the power meter.
For an overview about programming instruments via LAN, refer to the
connectivity guide.
Configuring the LAN remotely
To automatically configure the LAN settings enable DHCP operation using the
SYSTem:COMMunicate:LAN:DHCP[:STATe] command.
To individually specify the settings use the
SYSTem:COMMuniucate:LAN:ADDRess,
SYSTem:COMMunicate:LAN:SMASk,
SYSTem:COMMunicate:LAN:DGATeway,
SYSTem:COMMunicate:LAN:AIP[:STATe], and
SYSTem:COMMunicate:LAN:RESTart commands.
If you have installed other I/O software, refer to documentation that
accompanies the software.
To Next Page
Loading...
