Getting Started 1
Keysight N1911A and N1912A Installation Guide 29
Auto IP mode
Use this procedure if you require local PC Control or you are working in an isolated
(non-site) LAN.
1 Connect the computer to the power meter.
2 Switch the power on to the power meter.
3 Press ,
Remote Interfaces to display the Remote Interface display (see
Figure 1-3). Ensure that AutoIP is checked.
4 Press
Network AutoIP if you need to set any optional settings.
5 Press
Restart Network.
A pop-up appears for 5 seconds (see Figure 1-4). Monitor the Status at the
bottom of the display to see when the server has assigned an address.
6 Press , to return to a measurement screen.
7 If you intend to program over LAN or use such programs, make sure you have
installed I/O software on your PC.
8 Use the Connection Expert utility of the IO Libraries Suite to add the power
meter and verify a connection.
9 You can use various programming environments to control the power meter.
For an overview about programming instruments via LAN, refer to the
connectivity guide.
If you have installed other I/O software, refer to documentation that
accompanies the software.
To Next Page
Loading...
