Front Panel Menu Reference SCPI Command
Select Transient\Step.
Enter a value. Then press Select.
To seta trigger level for output 1 use:
VOLT:TRIG 15,(@1)
CURR:TRIG 1,(@1)
RES:TRIG 50,(@1)
POW:TRIG 75,(@1)
Selects the transient trigger source
Select a trigger source from the following:
Bus Selects GPIB device trigger, *TRG, or <GET> (Group Execute Trigger).
Imm An immediate trigger command either from the front panel or over the bus will generate an
immediate trigger.
Ext Selects all digital port pins that have been configured as trigger inputs.
Pin<n>Selects a specific pin that is configured as a Trigger Input on the digital port.<n> specifies the
pin number. The selected pin must be configured as a Trigger Input in order to be used as a trigger
source (refer to Trigger Input).
Transient<n> Selects the output channel’s transient system as the trigger source. <n> specifies the
channel. When you select a channel, you must also set up that channel’s transient system to
generate a trigger out signal. Refer to Generate Trigger Out Signals.
Use the following commands to select a trigger source:
Front Panel Menu Reference SCPI Command
To selectBus triggers, selectTransient\TrigSource.
Under Transient trigger source, selectBus.
To selectDigital pin triggers, select
Transient\TrigSource. Then selectone of the digital port
pins. (Ext selects all pins that have been configured as
trigger inputs.)
To selectTransient output triggers, select
Transient\TrigSource. Then selectone of the output
channels.
Then press Select.
To selectBus triggers for output 1:
TRIG:TRAN:SOUR BUS,(@1)
To selectImmediatetriggers for output 1:
TRIG:TRAN:SOUR IMM,(@1)
To selectDigital pin triggers: TRIG:TRAN:SOUR
PIN<n>,(@1)
where n is the pin number.
To selectTransient output triggers:
TRIG:TRAN:SOUR TRAN<n>,(@1)
where n is the output channel that will generate the
trigger signal
Initiate the transient trigger system
When the power system is turned on, the trigger system is in the idle state. In this state, the trigger
system is disabled, ignoring all triggers. Initiating the trigger system moves it from the idle state to the
initiated state, which enables the power system to receive triggers. To initiate the trigger system, use:.
Keysight N6700C Operating and Service Guide 105
4 Operating the Power System
To Next Page
Loading...
