*ESR? Returns event status register.
*IDN? Returns instrument identification.
*LRN? Returns a sequence of SCPI commands.
*OPC Enables "operation complete" bit in ESR.
*OPC? Returns a 1 when all pending operations complete.
*OPT? Returns option number.
*RCL<value> Recalls a saved instrument state.
*RDT? Returns output channel descriptions.
*RST Resets the instrument.
*SAV<value> Saves an instrument state.
*SRE <value> Sets service request enable register.
*STB? Returns the status byte.
*TRG Generates a trigger.
*TST? Performs a self-test, then returns results.
*WAI Pauses command processing until all device commands are done.
INITiate (ACQuire and ELOG commands only on N676xA, N678xA SMU, Option 054)
[:IMMediate]
:ACQuire (@chanlist) Initiates the measurement trigger system.
:ELOG (@chanlist) Initiates external data logging.
:TRANsient (@chanlist) Initiates the transient trigger system.
:CONTinuous
:TRANsient 0|OFF|1|ON, (@chanlist) Continuously initiates the transient trigger system.
LXI
:IDENtify
[:STATe] 0|OFF|1|ON Turns the front panel LXI identify indicator on or off.
:MDNS
[:STATe] 0|OFF|1|ON Controls the state of the mDNS server.
MEASure
[:SCALar]
:CURRent
[:DC]? (@chanlist) Takes a measurement; returns the averaged current.
:ACDC? (@chanlist) Takes a measurement; returns the RMS current (AC + DC).
:HIGH? (@chanlist) Takes a measurement; returns the High level of a current pulse.
:LOW? (@chanlist) Takes a measurement; returns the Low level of a current pulse.
:MAXimum? (@chanlist) Takes a measurement; returns the maximum current.
:MINimum? (@chanlist) Takes a measurement; returns the minimum current.
:POWer
[:DC]? (@chanlist) Takes a measurement; returns the averaged power. (N676xA, N678xA SMU)
:MAXimum? (@chanlist) Takes a measurement; returns the maximum power.
:MINimum? (@chanlist) Takes a measurement; returns the minimum power.
Keysight N6700C Operating and Service Guide 29
1 Quick Reference
To Next Page
Loading...
