Keysight N6700C Series - Page 30

:VOLTage
[:DC]? (@chanlist) Takes a measurement; returns the averaged voltage.
:ACDC? (@chanlist) Takes a measurement; returns the RMS voltage (AC + DC).
:HIGH? (@chanlist) Takes a measurement; returns the High level of a voltage pulse.
:LOW? (@chanlist) Takes a measurement; returns the Low level of a voltage pulse.
:MAXimum? (@chanlist) Takes a measurement; returns the maximum voltage.
:MINimum? (@chanlist) Takes a measurement; returns the minimum voltage.
:ARRay (ARRay commands only on N676xA, N678xA SMU and Option 054)
:CURRent
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous current.
:POWer
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous power. (N676xA, N678xA SMU)
:VOLTage
[:DC]? (@chanlist) Takes a measurement; returns the instantaneous voltage.
OUTPut
[:STATe] 0|OFF|1|ON [,NORelay], (@chanlist) Enables/disables the output.
:COUPle
[:STATe] 0|OFF|1|ON Enables/disables output coupling.
:CHANnel [<value>, {<value>}] Selects which channels are coupled.
:DOFFset <value> Sets a delay offset to synchronize coupled output state changes.
:MODE AUTO|MANual Specifies the output delay offset coupling mode.
:MAX
:DOFFset? Returns the delay offset required for this instrument.
:DELay
:FALL <value>, (@chanlist) Sets the output turn-off sequence delay.
:RISE <value>, (@chanlist) Sets the output turn-on sequence delay.
:PMODE VOLTage|CURRent, (@chanlist) Sets the mode for turn-on/off transitions. (N6761A, N6762A)
:TMODE HIGHz|LOWZ, (@chanlist) Specifies the turn-on/turn-off impedance. (N678xA SMU)
:INHibit
:MODE LATChing|LIVE|OFF Sets the operating mode of the remote inhibit digital pin.
:PON
:STATe RST|RCL0 Set the output power-on state.
:PROTection
:CLEar (@chanlist) Resets the latched protection.
:COUPle0|OFF|1|ON Enables/disables channel coupling for protection faults.
:DELay <value>, (@chanlist) Sets the over-current protection programming delay.
:OSCillation0|OFF|1|ON, (@chanlist) Enables/disables output oscillation protection. (N678xA SMU)
:TEMPerature
:MARGin? (@chanlist) Returns the margin remaining before the over-temperature trips.
:WDOG
[:STATe] 0|OFF|1|ON Enables/disables the I/O watchdog timer.
:DELay <value> Sets the watchdog delay time.
1 Quick Reference
30 Keysight N6700C Operating and Service Guide