Keysight N6700C Series - Page 307

[SOURce:]VOLTage:SLEW[:POSitive]:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]VOLTage:SLEW[:POSitive]:MAXimum? (@<chanlist>)
[SOURce:]VOLTage:SLEW:NEGative:MAXimum 0|OFF|1|ON, (@<chanlist>)
[SOURce:]VOLTage:SLEW:NEGative:MAXimum? (@<chanlist>)
Enables/disables the maximum slew rate override. When enabled, the slew rate is set to its maximum
value. When disabled, the slew rate is set to the immediate value set by VOLTage:SLEW. Use
VOLTage:SLEW? MAX to query the maximum slew rate.
Parameter Typical Return
0|OFF|1|ON, *RST OFF 0or1
Enable the maximum slewrate override: VOLT:SLEW:MAX ON, (@1)
Enable the negative maximum slewrate: VOLT:SLEW:NEG:MAX ON, (@1)
l The VOLTage:SLEW:MAX command is coupled to the VOLTage:SLEW command. If the
VOLTage:SLEW command sets the slew rate to MAX or INFinity, VOLTage:SLEW:MAX is enabled.
If the slew rate is set to any other value, VOLTage:SLEW:MAX is disabled.
Keysight N6700C Operating and Service Guide 307
5 SCPI Programming Reference