Keysight N6700C Series - Page 35

[SOURce:]
DIGital
:INPut
:DATA? Reads the state of the digital control port.
:OUTPut
:DATA <value> Sets the state of the digital control port.
:PIN<1-7>
:FUNCtion <function> Sets the function of the pins. DIO |DINPut |FAULt |INHibit
|ONCouple |OFFCouple |TOUTput |TINPut
:POLarity POSitive|NEGative Sets the polarity of the pins.
:TOUTput
:BUS
[:ENABle] 0|OFF|1|ON Enables/disables BUS triggers on digital port pins.
[SOURce:]
FUNCtion CURRent|VOLTage|RESistance|POWer, (@chanlist) Sets the output priority mode). (N678xA SMU, N679xA)
[SOURce:]
LIST (LIST commands only on N676xA, N678xA SMU and Option 054)
:COUNt <value>|INFinity, (@chanlist) Sets the list repeat count.
:CURRent
[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
:DWELl <value>{,<value>}, (@chanlist) Specifies the dwell time for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
:POWer
[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step. (N679xA)
:POINts? (@chanlist) Returns the number of list points (same as steps).(N679xA)
:RESistance
[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step. (N679xA)
:POINts? (@chanlist) Returns the number of list points (same as steps).(N679xA)
:STEP ONCE|AUTO, (@chanlist) Specifies how the list responds to triggers.
:TERMinate
:LAST 0|OFF|1|ON, (@chanlist) Determines the output value when the list terminates.
:TOUTput
:BOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist) Generates a trigger out at the Beginning Of STep
:POINts? (@chanlist) Returns the number of list points (same as steps).
:EOSTep
[:DATA] <Bool>{,<Bool>}, (@chanlist) Generates a trigger out at the End Of STep
:POINts? (@chanlist) Returns the number of list points (same as steps).
:VOLTage
[:LEVel] <value>{,<value>}, (@chanlist) Specifies the setting for each list step.
:POINts? (@chanlist) Returns the number of list points (same as steps).
Keysight N6700C Operating and Service Guide 35
1 Quick Reference