Keysight N6700C Series - Page 36

[SOURce:]
POWer
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the input power level. (N679xA)
:TRIGgered
[:AMPLitude] <value>, (@chanlist) Sets the triggered input power. (N679xA)
:LIMit <value>, (@chanlist) Sets the power limit on output channels. (not on N678xA)
:MODE FIXed|STEP|LIST|ARB, (@chanlist) Sets the power transient mode. (N679xA)
:PROTection
:DELay
[:TIME] <value>, (@chanlist) Sets the power protection delay. (N679xA)
:STATe 0|OFF|1|ON, (@chanlist) Enables/disables the power protection. (N679xA)
:RANGe <value>, (@chanlist) Sets the power range. (N679xA)
:SLEW
[:POSitive]
[:IMMediate] <value>|INFinity, (@chanlist) Sets the power slew rate. (N679xA)
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override. (N679xA)
:COUPle 0|OFF|1|ON, (@chanlist) Sets the power slew tracking state. (N679xA)
:NEGative
[:IMMediate] <value>|INFinity, (@chanlist) Sets the negative power slew rate. (N679xA)
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override. (N679xA)
[SOURce:]
RESistance
[:LEVel]
[:IMMediate]
[:AMPLitude] <value>, (@chanlist) Sets the output resistance level. (N6781A, N6785A, N679xA)
:TRIGgered
[:AMPLitude] <value>, (@chanlist) Sets the triggered resistance. (N679xA)
:MODE FIXed|STEP|LIST|ARB, (@chanlist) Sets the resistance transient mode. (N679xA)
:RANGe <value>, (@chanlist) Sets the resistance range. (N679xA)
:SLEW
[:POSitive]
[:IMMediate] <value>|INFinity, (@chanlist) Sets the resistance slew rate. (N679xA)
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override. (N679xA)
:COUPle 0|OFF|1|ON, (@chanlist) Sets the resistance slew tracking state. (N679xA)
:NEGative
[:IMMediate] <value>|INFinity, (@chanlist) Sets the negative resistance slew rate. (N679xA)
:MAXimum 0|OFF|1|ON, (@chanlist) Enables/disables the maximum slew rate override. (N679xA)
:STATe 0|OFF|1|ON, (@chanlist) Enables/disables output resistance programming. (N6781A, N6785A)
1 Quick Reference
36 Keysight N6700C Operating and Service Guide