Keysight N777 C Series - Command Summary

20 Keysight N777xC Series Tunable Laser Family Programming Guide
2 Command Summary
Command Summary
The commands are ordered in a command tree. Every command belongs
to a node in this tree.
The root nodes are also called the subsystems. A subsystem contains all
commands belonging to a specific topic. In a subsystem there may be
further subnodes.
Table 4 on page 20 gives an overview of the command tree. You see the
nodes, the subnodes, and the included commands.
Table 4 Command Summary
Command Page
CONFigure Subsystem
:CONFigure:MEASurement:SETTing:ACTual? Page 83
:CONFigure:MEASurement:SETTing:NUMBer? Page 83
:CONFigure:MEASurement:SETTing:PRESet Page 83
:CONFigure:MEASurement:SETTing:CANCel Page 84
:CONFigure:MEASurement:SETTing:RECall Page 84
:CONFigure:MEASurement:SETTing:SAVE Page 84
:CONFigure:MEASurement:SETTing:ERASe Page 85
Command Page
SOURce Subsystem
:SOURce0:AM:COHCtrl:COHLevel? Page 63
:SOURce0:AM:COHCtrl:COHLevel Page 63
:SOURce0:AM:SOURce? Page 64
:SOURce0:AM:SOURce Page 64
:SOURce0:AM:STATe Page 64
:SOURce0:AM:STATe? Page 65