Keysight N777 C Series - Trigger[N]:Input; Trigger[N]:Output

Keysight N777xC Series Tunable Laser Family Programming Guide 87
Measurement Operations & Settings 4
Command: :TRIGger[n]:INPut?
Syntax: :TRIGger[n]:INPut?
Description: Returns the incoming trigger response.
Parameters: None
Response: IGNore:
NEXTstep:
SWStart:
Ignore incoming trigger.
Perform next step of a stepped sweep.
Start a sweep cycle.
Example: :trig0:inp? -> ign
Affects: All tunable laser modules
Command: :TRIGger[n]:OUTPut
Syntax: :TRIGger[n]:OUTPut
Description: Specifies when an output trigger is generated and arms the module.
Parameters: DISabled:
STFinished:
SWFinished:
SWSTarted:
Never.
When a sweep step finishes.
When sweep cycle finishes.
When a sweep cycle starts.
Response: None
Example: :trig0:outp dis
Affects: All tunable laser modules
Command: :TRIGger[n]:OUTPut?
Syntax: :TRIGger[n]:OUTPut?
Description: Returns the condition that causes an output trigger.
Parameters: none