Keysight N777xC Series Tunable Laser Family
Programming Guide
3 Instrument Setup and
Status
IEEE-Common Commands / 28
Status Reporting – The STATus Subsystem / 34
Interface/Instrument Behaviour Settings – The SYSTem Subsystem / 41
System Communicate - The :SYST:COMMunicate sub tree / 45
This chapter gives descriptions of commands that you can use when
setting up your instrument. The commands are split into the following
separate subsytems:
• IEEE specific commands that were introduced in Common Commands on
page 16.
• STATus subsystem commands that relate to the status model.
• SYSTem subsystem commands that control the serial interface and
internal data.
To Next Page
Loading...
