3 Spectrum Analyzer Mode
3.5 ACP Measurement
Remote
Command
[:SENSe]:ACPower:CARRier[1]|2:RCARrier:AUTO OFF | ON | 0 | 1
[:SENSe]:ACPower:CARRier[1]|2:RCARrier:AUTO?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR:RCAR:AUTO OFF
:ACP:CARR:RCAR:AUTO?
Couplings If you enter a ref carrier this parameter will be set to manual
Preset 1
State Saved Yes
Range Auto | Man
Backwards
Compatibility
SCPI
[:SENSe]:MCPower:RCARrier[1]|2:AUTO
(Power Suite)
Carrier Index (Modes: MSR, LTEAFDD, LTEATDD, and 5GNR)
Remote Command
[:SENSe]:ACPower:CARRier[1]|2:INDex <integer>
[:SENSe]:ACPower:CARRier[1]|2:INDex?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR:IND 1
:ACP:CARR:IND?
Notes Note that Carrier subopcode 2 is not supported in some Modes. In those cases, Carrier subopcode 1
is used for both BTS and MS and commands with subopcode 2 are accepted without error but ignored
Dependencies Only appears in MSR, LTEAFDD, LTEATDD and 5G NR Modes
Preset 1
State Saved Saved in instrument state
Min/Max LTEAFDD, LTEATDD: 1/Dependent on Num Component Carriers
5G NR: 1/Dependent on Num Component Carriers
MSR: 1/100
Carrier Index Zero Base (Remote Command Only)
Remote Command
[:SENSe]:ACPower:CARRier[1]|2:RCARrier:ZBASe <integer>
[:SENSe]:ACPower:CARRier[1]|2:RCARrier:ZBASe?
Subopcode: 1 = BTS/Downlink (Default), 2 = MS/Uplink
Example
:ACP:CARR:RCAR:ZBAS 1
:ACP:CARR:RCAR:ZBAS?
Spectrum Analyzer Mode User's &Programmer's Reference 1053
To Next Page
Loading...
