Keysight N9020B - Meas Preset; Max Hold (Remote Command Only)

3 Spectrum Analyzer Mode
3.4 Occupied BW Measurement
–
Zero span measurement Resolution Bandwidth
–
Zero span measurement Dwell Time
Harmonics (SA Mode only)
Parameters affected by Auto Couple are:
–
Resolution Bandwidth
–
Fundamental Frequency
–
Dwell Time
–
Range Table Resolution Bandwidths
–
Range Table Dwell Times
Meas Preset
Restores all measurement parameters to their default values.
Remote Command
:CONFigure:OBWidth
Example
:CONF:OBW
Max Hold (Remote Command Only)
When ON, Max Hold displays and holds the maximum responses of the current
measurement. Turn Max HoldOFF to disable the maximum hold feature.
Remote
Command
[:SENSe]:OBWidth:MAXHold ON | OFF | 1 | 0
[:SENSe]:OBWidth:MAXHold?
Example
:OBW:MAXH ON
:OBW:MAXH?
Couplings Max Hold is coupled to "Averaging On/Off" on page 799. Max Hold is activated only if Average state is
ON. If Max Hold is changed to ON when Average state is OFF, Average state is automatically set to ON
Preset
OFF
State Saved Yes
Range
OFF|ON
Backwards
Compatibility
SCPI
[:SENSe]:EBWidth:MAXHold
Spectrum Analyzer Mode User's &Programmer's Reference 805