Keysight N9020B - Page 36

Table Of Contents
IF Gain 1460
Detector/Sweep 1460
Frequency Range 1460
Enabled 1461
Start Freq 1461
Stop Freq 1461
Center Frequency 1461
Span 1461
Sweep Time 1461
Points 1462
Detector 1 1463
Detector 2 1464
Limits 1465
Frequency Range 1465
Enabled 1465
Start Freq 1465
Stop Freq 1465
Center Frequency 1465
Span 1466
Abs Start Limit 1466
Abs Stop Limit 1467
Peak Excursion 1468
Pk Threshold 1469
Meas Setup Summary Table 1469
Auto Couple 1469
Meas Preset 1471
Fast Spurious Meas (Remote Command only) 1471
3.8.8.2 Meas Standard 1472
Radio Standard Presets 1472
Enable Non-Std Meas 1486
3.8.8.3 Advanced 1486
Noise Floor Extension 1487
3.8.8.4 Global 1490
Global Center Freq 1491
Global EMC Std 1491
Global Limit Lines (Freq and Amptd) 1492
Extend Low Band 1493
Restore Defaults 1493
3.8.9 Sweep 1493
3.8.9.1 Sweep/Control 1494
Sweep/Measure 1494
Restart 1496
Pause/Resume 1498
Abort (Remote Command Only) 1499
3.8.9.2 Sweep Config 1499
Sweep Type 1499
36 Spectrum Analyzer Mode User's &Programmer's Reference