Keytroller Smarter - Pre-Installation Safety Checks; Installation Site and Environment Checks; Unit Mounting Orientation; Installing the Main Unit

7
Installation:



InstallingtheUnit

1.Inserttheholderintothe
mountingconnection.



InstallingtheRemoteExternalAlarmButton









3.Cleanthemounting
surfacewithalcoholand
removetheredfilmfrom
tapethemount,andpressin
placethemounttothe
windshieldtightly
2.InserttheIRlightmodule’sknob,
ontherarefaceofthebody.Only
connectpowercordtotheIRlight
afteritiscon
nectedtocamera
1.InserttheJackofthemanualalarminputcable
intotheconnectionportontheupperpartofthe
CigaretteLighterPlug.RuntheCable,hidingand
securingitinplace.
2.Locatethebestpositionfortheremotealarm
button.Securethebuttonbyremovingtheadhesive
filmattachedtothetapeontheexternalbutton,
pressandhold
.
• Be sure to stop the engine before installing the product.
• Remove all power to any areas where wires will be connected.
• Install in a location where the GPS signal will be received
• Before permanently mounting the unit, ensure that the camera views meet your
requirements. (ex: where the interior view is not hidden by the mirror inside your car)
•
S
S
M
M
A
A
R
R
T
T
E
E
R
R
must be installed on the mounted straight both horizontally and vertically
CAUTION!! Before Installing