45English
Change LED
Color
Change LED
Brightness
When the desired voltage is shown
(reference power chart at KICKER.com), or
you start to see the waveform square off
stop increasing the gain, turn the amplifier
off, reconnect all speakers and set the
crossovers to your desired setting. Your
gain is now set for maximum unclipped
power from the amplifier. If you increase
amplitude using settings on the source unit
or the bass boost on the amplifier it will
introduce distortion and you will need to
redo these steps.
LED Accent Lighting: Remove the top
panel cover to access the LED Accent
Lighting Controls.
Press the Change LED Color button to
cycle through the available colors. Press
the Change LED Brightness to change the
intensity of the light, or to turn it off.
Available Colors:
Red Magenta Violet
Blue Light Blue Cyan
Dark Green Green Yellow
Orange White
To Next Page
