22
Error codes
Err01: The weight signal is too large.
Err02: No proper data can be displayed.
Err03: The weight signal is too small.
Err04: Zero point is over the setting range.
Err05: Zero point is below the setting range.
Err06: Error in unit key operation.
Err10: The EEPROM can’t be accessed.
Err11: The parameters are not same with backup data.
Err12: The setting parameter(s) is not in normal range.
Err20: There is an error in calibration.
Err30: ADC is over max. range.
Err31: ADC is below min. range.
Err40: Recall error, no content stored.
CAP.: Capacity.
UOL.: Voltage.
St.PLU: To set and store the indirect unit price.
ADDR. : PLU address.
Unit: Weighing unit selecting.
Rc.PLU: Recall indirect unit price.
OUT.P.R: Data is out of printed barcode range.
Data.ch: Data has been changed.
Save: Data is being saved.
O.RANGE:
The data has been entered or the weight for tare weight is out of range.
To Next Page
Loading...
