Kinco FV20 - Page 39

Chapter 6 List of Parameters
77
Function
code
Name Descriptions Unit
Factory
setting
Modif
.
Setting
range
5: MAX(AI1 AI2)
6: DI
C1.03 Digital setting ofreference -10.00V 10.00V 0.01 0.00 O 0 2000
C1.04 Close-loop speed
reference
0 39000RPM 1RPM 0 O 0 39000
C1.05 Min reference 0.0% (C1.07)(Ratio of Min reference
to base value of 10V/20mA)
0.1% 0.0% O 0 1000
C1.06 Feedback value
corresponding to the Min
reference
0.0 100.0%(Ratio of Min reference to
base value of 10V/20mA)
0.1% 0.0% O 0 1000
C1.07 Max reference (A01.05) 100.0%(Ratio of Max
reference to base value of 10V/20mA)
0.1% 100.0% O 0 1000
C1.08 Feedback value
corresponding to the Max
reference
0.0 100%(Ratio of Max reference to
base value of 10V/20mA)
0.1% 100.0% O 0 1000
C1.09 Proportional gain KP 0.000 10.000 0.001 2.000 O 0 10000
C1.10 Integral gain Ki 0.000 10.000 0.001 0.100 O 0 10000
C1.11 Differential gain Kd 0.000 10.000 0.001 0.100 O 0 10000
C1.12 Sampling cycle T 0.01 50.00s 0.01s 0.50s O 1 5000
C1.13 Output filter 0.01 10.00s 0.01s 0.05 O 1 1000
C1.14 Error limit 0.0 20.0%(Corresponding to
close-loop reference)
0.1% 2.0% O 0 200
C1.15 Close-loopregulation
characteristic
0: Positive
1: Negative
1 0 X 0 1
C1.16 Integral regulation
selection
0: Stop integral regulation when the
frequency reaches the upper and lower
limits
1: Continue the integral regulation
when the frequency reaches the upper
and lower limits
1 0 X 0 1
C1.17 Preset close-loop
frequency
0.00 300.00Hz 0.01Hz 0.00Hz O 0 30000
C1.18 Holding time of
preset close-loop
frequency
0.0 3600.0s 0.1s 0.0s X 0 36000
C1.19 Preset close-loop
reference 1
-10.00V 10.00V 0.01V 0.00V O 0 2000
C1.20 Preset close-loop
reference 2
-10.00V 10.00V 0.01V 0.00V O 0 2000
C1.21 Preset close-loop
reference 3
-10.00V 10.00V 0.01V 0.00V O 0 2000
C1.22 Preset close-loop
reference 4
-10.00V 10.00V 0.01V 0.00V O 0 2000
C1.23 Preset close-loop
reference 5
-10.00V 10.00V 0.01V 0.00V O 0 2000