RO Compact Series Technical Manual
14
The Components
The following components are used in the
RO-Compact series.
1
Inlet:
The connection is a stainless steel, 3/4” BPS
male nipple.
2
Outlet:
The connection is a 3/4” BSP male nipple.
Permeate line from the TC RO should be made
with stainless steel or plastic.
3
Permeate Reservoir:
A 35 / 66 litres polypropylene container is used
to store permeate water. The material is ideal for
the storage of reverse osmosis quality water.
4
Delivery Pump:
A multi-stage centrifugal pump. This pump will
pressurise the permeate water to 3 bar, at a flow
rate of 1200 l/h.
5
Non-Return Valve:
Located after the distribution pump, it prohibits
water from back-flowing into the permeate
reservoir.
6
Reservoir Overflow Connection:
A 1/2”(C1) 1”(C2,C3) tubing connection is to be
made to drain. This drain is a safety for the
overflow of the permeate reservoir.
7
Electrical Connection:
A (1.5 mm
2
) cable is supplied with the unit. The
cable must be attached to an approved electrical
connector (plug).
Supply Power Required: 230 VAC, 1 Phase,
50 Hz.
8
Drain (Reject) Connection:
A 10mm push style connection is used to make
the drain connection.
Do not restrict the drain connection, as this
could result in the building of pressure in excess
of 15 bar.
9
Feed Solenoid Valve:
A brass, normally closed (NC) solenoid valve is
used to shut flow o to the system during
shutdown conditions.
10
Non-Return Valve:
An in-line non-return valve is used to prevent
back-flow from the system.
11
Inlet Pump:
The rotary vane pressurization pump provides
pressure to the RO-Compact series as required
for proper operation.
The motor used with this pump is of TEFC
construction.
The fan also provides air circulation within the
top cover of the cabinet, helping to regulate
the temperature of the electronics. The pump
is design to deliver 1,000 l/h at 12 bar pressure.
To Next Page
Loading...
Need help?
General
