Document No. 480-15FUM-001.A00
Kingston MobileLite Wireless
Settings and Configuring MobileLite Wireless
Using the MobileLite Wireless App, the user can customize the wireless network settings for MobileLite Wireless.
The default settings (assuming nothing was changed during the initial setup) are: Device Name:
MobileLiteWireless, Visibility Status: ON, Wireless Channel: 11, and Security: Off.
To access MobileLite Wireless’s Network Settings, please follow these steps:
1. From the ‘Homescreen’, select ‘Menu’
Name – commonly referred to as an SSID, or Service Set
IDentifier, this field allows users to specify a device name
(between 1 and 32 characters) that will broadcast in the list
of available wireless networks on your iPad, iPhone, or iPod
touch device. The default name is MobileLite Wireless as
seen in Figure 18.
Battery Life - indicates amount of charge left in battery
Firmware – MLW device firmware
Visibility – this gives you the option to hide or unhide the
SSID specified in the ‘Name’ field. By default, the visibility
status is turned ‘ON’. If you wish to turn this feature ‘OFF’,
the device name will NOT be broadcasted
1
in the list of
available wireless networks on your iPad, iPhone, or iPod
touch device; however, you can still join the Wi-Fi network
by entering the device name manually using the menu
option, ‘Other…’.
Wireless Channel – this setting allows you to select a
specific frequency channel used to communicate with other
devices on your wireless network. The default setting is
Channel 11 (2.462 GHz.)
Figure 18 – MobileLite Wireless Network
Settings
Security (WPA2) – this option helps prevent unauthorized access to your MobileLite Wireless device by
prompting users for a password. Simply enter a password in the 'Password' field and confirm it by re-typing it
in the 'Confirm Password' field and tap the 'Done' button to save the MobileLite Wireless settings.
1
If the visibility status has been turned off, you can still join the MobileLite Wireless network by entering the SSID manually on your iPad,
iPhone, or iPod touch, as long as you know the ‘Device Name’ (Step A). Please note that a password will be required if the security option is
enabled.
To Next Page
Loading...
