Chapter 1 Before Use 1-6
1. 4. 2 Printer part
Subject Specification
Printing method LED Array Electro photography
Photoreceptor Organic Photoconductive Drum
Print speed 80mm per second
(Inch) 3.4ppm/E 5.8ppm/D Landscape
(Metric) 3.3ppm/A0 5.6ppm/A1 Landscape
Print head LED Array
Resolution of print head
600dpi x 2400dpi
Print width Maximum 914mm / 36”
Minimum or 297mm / 11” (roll media)
or 210mm / 8.5” (cut sheet)
Print length Maximum
(Standard) 6,000mm / 19.7ft for 36” / A0 wide
(plain paper / bond)
or “5 x Standard length” (plain paper / bond)
“2 x Standard length”
(tracing paper / vellum)
“1 x Standard length”
(film)
(Option) 64,000mm
Minimum 210mm / 8.5”
NOTE :
If the print is longer than the mentioned above, its image quality or the reliability of paper
feeding is not guaranteed.
Paper feeding method 2 Roll Decks
Manual Feeder (single cut sheet)
Paper tray (multiple cut sheet, option)
Print size
(from Paper Tray, option)
ISO (mm)
Width
Length
ANSI (inch)
Width
Length
Warm up time Shorter than 4 minutes 30 seconds
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
First print time 21 seconds (D Landscape, Front Stacking)
(At 23
o
C, 60%RH, the rated voltage, and plain paper is used)
Fusing method Heat and Pressure Rollers
Development method Dry type non-magnetic mono-component toner
594 420 297 210
420 X X
297 X X
24 22 18 17 12 11 9 8.5
18 X X
17 X X
12 X X
11 X X
To Next Page
Loading...
