KIP 7970 - Page 58

Chapter 3 Error Correction 3-15
12. Hold the thick wire parts of the tray and insert the hook parts at the “lock position” on the top
face of the printer’s rear beam.
NOTE
(1) Do not hold a thin wire to carry the entire tray.
(2) Ejected prints will be stacked incorrectly on Print Tray until you move it from “release
position” to “operation position”.
Hold the wire
(
s
)
here
Lift u
p
the entire tra
y
Hold the wire
(
s
)
here
O
p
eration Position
Release Position
O
p
eration Position